As we all know, machines need regular maintenance and cleaning. Otherwise, the parts of the machine will become dirty and difficult to use. So, do you know how to clean a vacuum quantitative filling machine? And what should we pay attention to when cleaning?

(1) Whenever the vacuum pump's vacuum level decreases near the end of each batch of material filling, it is necessary to shut down the vacuum pump, set the punching machine to manual mode, and use a foot-operated switch to control the discharge of a small amount of material. At this point, there should be no vacuum state.

(2) Open the vacuum cylinder cover and add an appropriate amount of clean water into the hopper for cleaning. Select the direct-flow mode and set the speed to 200 rpm. Then, use the foot-operated switch to control the water discharge until it is completely drained. Finally, turn off the power.

(3) Release the clamping handle to tip the hopper over, remove the inner stator, and use the included special tool for lifting the impeller to simultaneously extract the impeller and blades. Place them in clean water for cleaning, rinse and wipe the pump chamber clean, and return the hopper to its original position.

(4) When not in use for a long time, please apply cooking oil to the impeller, pump chamber, blades, etc.

(5) When cleaning, be sure to turn on the vacuum pump strictly, otherwise the vacuum pump may be damaged due to water ingress.

All the above viewpoints are compiled and published by Shijiazhuang Tianfa Machinery Equipment, sourced from http://www.tianfajixie.com/